Wlp10s0b1: BSS: Start scan result update 1 Received 5573 bytes of scan results (10 BSSes) Scan results did not fit - trying larger buffer (8192 bytes) Wlp10s0b1: Event SCAN_RESULTS (3) received Scan requested (ret=0) - scan timeout 10 seconds Wlp10s0b1: Starting radio work after 0.000018 second wait Wlp10s0b1: Add radio work First radio work item in the queue - schedule start immediately Wlp10s0b1: Starting AP scan for wildcard SSID Wlp10s0b1: State: DISCONNECTED -> SCANNING WEXT: if_removed already cleared - ignore event RTM_NEWLINK, IFLA_IFNAME: Interface 'wlp10s0b1' added RTM_NEWLINK: operstate=0 ifi_flags=0x1003 () Netlink: Operstate: ifindex=3 linkmode=-1 (no change), operstate=5 (IF_OPER_DORMANT) Wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT) Wlp10s0b1: State: DISCONNECTED -> DISCONNECTED Wlp10s0b1: WPS: UUID based on MAC address: 4fc09d5a-bacc-5514-9fe3-6171763ff742ĮAPOL: SUPP_PAE entering state DISCONNECTEDĮAPOL: Supplicant port status: UnauthorizedĮAPOL: KEY_RX entering state NO_KEY_RECEIVEĬtrl_interface_group=10 (from group name 'wheel') TDLS: Driver does not support TDLS channel switching TDLS: TDLS operation not supported by driver Wlp10s0b1: Setting scan request: 0.100000 sec Wlp10s0b1: RSN: flushing PMKID list in the driver Wpa_driver_wext_set_key: alg=0 key_idx=5 set_tx=0 seq_len=0 key_len=0 Wpa_driver_wext_set_key: alg=0 key_idx=4 set_tx=0 seq_len=0 key_len=0 Wpa_driver_wext_set_key: alg=0 key_idx=3 set_tx=0 seq_len=0 key_len=0 Wpa_driver_wext_set_key: alg=0 key_idx=2 set_tx=0 seq_len=0 key_len=0 Wpa_driver_wext_set_key: alg=0 key_idx=1 set_tx=0 seq_len=0 key_len=0 Wpa_driver_wext_set_key: alg=0 key_idx=0 set_tx=0 seq_len=0 key_len=0 Netlink: Operstate: ifindex=3 linkmode=1 (userspace-control), operstate=5 (IF_OPER_DORMANT)Īdd interface wlp10s0b1 to a new radio phy0 SIOCGIWRANGE: WE(compiled)=22 WE(source)=21 enc_capa=0xfĬapabilities: key_mgmt 0xf enc 0x1f flags 0x0 Rfkill: initial event: idx=9 type=2 op=0 soft=0 hard=0 Rfkill: initial event: idx=1 type=1 op=0 soft=0 hard=0 Reading configuration file '/home/timur/.config/wpa_nf'Ĭtrl_interface='DIR=/var/run/wpa_supplicant GROUP=wheel' Initializing interface 'wlp10s0b1' conf '/home/timur/.config/wpa_nf' driver 'n180211,wext' ctrl_interface 'N/A' bridge 'N/A'Ĭonfiguration file '/home/timur/.config/wpa_nf' -> '/home/timur/.config/wpa_nf' Last edited by timfayz ( timur]# wpa_supplicant -dd -Dn180211,wext -i wlp10s0b1 -c/home/timur/.config/wpa_nf Trying to associate with 20:4e:7f:3b:86:1d (SSID='Hangglide' freq=2422 MHz)ĬTRL-EVENT-DISCONNECTED bssid=20:4e:7f:3b:86:1d reason=0ĬTRL-EVENT-SSID-TEMP-DISABLED id=0 ssid="Hangglide" auth_failures=2 duration=23 reason=CONN_FAILED WPA: 4-Way Handshake failed - pre-shared key may be incorrectĬTRL-EVENT-SSID-TEMP-DISABLED id=0 ssid="Hangglide" auth_failures=1 duration=10 reason=WRONG_KEYĬTRL-EVENT-SSID-REENABLED id=0 ssid="Hangglide" This software may be distributed under the terms of the BSD license.Īuthentication with 20:4e:7f:3b:86:1d timed out.ĬTRL-EVENT-DISCONNECTED bssid=20:4e:7f:3b:86:1d reason=3 locally_generated=1 Ioctl: Invalid timur]# wpa_cliĬopyright (c) 2004-2015, Jouni Malinen and contributors Wheel audio timur]# cat /home/timur/.config/wpa_nfĬtrl_interface=DIR=/var/run/wpa_supplicant timur]# wpa_supplicant -i wlp10s0b1 -B -Dn180211,wext -c/home/timur/.config/wpa_nf
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |